Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 04/08/20 in Posts

  1. 2 points
    GravelRash

    Post your GT86 / BRZ pic of day!

    Cheeky.
  2. 1 point
    likaito

    Budget Build - Kai's Primo daily

    Of course. This is the ballast. Need to buy 2 obviously, one for each light: https://www.ebay.co.uk/itm/12v-35w-Conversion-kit-Slimline-Xenon-Hid-Slim-BALLAST/170823543539?pageci=311b7095-9934-4b03-89c5-96e05272f5c6 These are the bulbs. Just cheap ones because I wanted to test. Surprisingly good output, no worse than my old ones: https://www.ebay.co.uk/itm/New-2-x-D2H-Cnlight-XLX-Xenon-Bulb-Car-HID-Projector-Lens-Lamp-Bulbs-12V-35W/283484807138?pageci=518a566c-4ffd-47a1-8587-e4aeaa3972e6 Hope that helps 😊
  3. 1 point
    likaito

    Budget Build - Kai's Primo daily

    So fitted the VLAND bumper light to complete the VLANDs all around. Straightforward install, took around an hour and a half. The hardest bit was getting off the 2 rusted 10mm bolts holding it on. Apart from that, just unplugged and removed stock one then replaced with the new one. The wiring is super super easy, plug and play. There's an additional harness that plugs into the tail lights and connects the extra wire to the bumper light for the brake light to work. Job done. Super easy install. Very happy to complete the look and remove that chromey bumper light. The reason I went for the VLANDs and not the Valenti ones with a V bar is just because these are way less common from what I've seen (they seem to be the only choice) and way cheaper. Plus I think they compliment the tail lights well and are just different. Pictures are a bit crap because the sun was directly on the car, will try and get some decent pics in the next day or so after I install the sunstrip 😊😊
  4. 1 point
    GravelRash

    Post your GT86 / BRZ pic of day!

    I did an advanced driving course and had a 'minor' incident that damaged the front bumper and the underpanels, which also explains the quick release buttons. I need to fix the inner one on the side shown as it's not engaging properly. Not shown is the Beatrush undertray cooling panel as well. Complete with a new screamer hole. Nothing like drilling into a pristine brand new aftermarket part to void a warranty.
×