Rtb 4 Report post Posted September 29, 2018 Hi All Want to run Recaros for track and I don't want to see airbag lights etc, anybody have a workaround to put out airbag lights etc....im going to keep seat belts etc. p.s will passenger seat be a problem in regards to "seat sensor mat" etc....any advice would help. regards Russ Share this post Link to post Share on other sites
KevinA 695 Report post Posted September 29, 2018 I just put resistors in and no problems Share this post Link to post Share on other sites
smudge 1020 Report post Posted September 29, 2018 3 hours ago, KevinA said: I just put resistors in and no problems 3.3ohm for airbag sensors isn't it Kev? Share this post Link to post Share on other sites
Rtb 4 Report post Posted September 30, 2018 On 29/09/2018 at 6:21 PM, KevinA said: I just put resistors in and no problems Ok so resistors both sides only......then no lights...passenger side works same as drivers?...one resistor each side? Share this post Link to post Share on other sites
KevinA 695 Report post Posted October 1, 2018 2.1 ohms for air bags. Share this post Link to post Share on other sites
Rtb 4 Report post Posted October 3, 2018 Hi Kev Car looks great from pics....Thanks for info......but please could you clarify you only used resistors on both seats and as to weather you had to use oem passenger sensor mat from oem seats..... regards Russell Share this post Link to post Share on other sites