The Minion 63 Report post Posted August 25, 2018 Passenger window closing too high, not opening slightly when opening and closing door.If I open window fully and then 'one shot' it the window goes right up and then about two thirds down.I have tried the obstruction reset but makes no difference.I have just had a bit of work done on this door which would have involved internal removal.Any ideas or is it a trip to Toyota? Share this post Link to post Share on other sites
nikndel 509 Report post Posted August 25, 2018 I had a issue similar to this with drivers door it was the black button in the door shut the window was doing what it wanted but no work had been done to my door Share this post Link to post Share on other sites
The Minion 63 Report post Posted August 25, 2018 I think the glass runner has gone past the sensor. I was washing the car and pressed the aforementioned button on door frame whilst door open. The window went up, as I would expect, but half an inch too far. The reason I pressed the button was because I had a problem before where the window wouldn't rise and fall when door opened and closed, found that the button was loose. This was also because internals had been removed for paint spray work. The paint wasn't quite right so hence going back in. Share this post Link to post Share on other sites