Adi 40 Report post Posted October 11, 2019 Looks like reverse lockout ring pin is missing, I can shine a light through the hole with a flashlight or put a very thin screwdriver through the hole, the pin is not there. Nevertheless, I cannot remove the lockout and the whole thing behaves like the pin is there. I only noticed this because I was trying to remove the lockout to put some Teflon tape on the shaft to stop the rattling above 5k rpm. Any ideas what is going on and how to remove he lockout ? Share this post Link to post Share on other sites
Adi 40 Report post Posted October 11, 2019 Solved. It's a roll pin: https://www.ft86club.com/forums/showthread.php?p=3266211#post3266211 Share this post Link to post Share on other sites
JohnM 25 Report post Posted October 11, 2019 Use a hardened nail to remove it unless you have a punch tool. Mine was a pain in the arse to remove when i changed over the reverse lockout. Also put a towel in front of the heater surround in case you miss with the hammer. Also if you are taking the lockout off make sure it is in reverse gear before removing otherwise you will have to remove the centre console to put the mechanism back in place. Share this post Link to post Share on other sites
MartinT 514 Report post Posted October 12, 2019 Yep, it's a hollow pin just to make things more difficult. I bought a pin punch to do mine as nothing else worked.Sent from my LG-Q6 using Tapatalk Share this post Link to post Share on other sites
michael h 0 Report post Posted March 18, 2020 If i flair the pin how do i go abouts drilling out the pin? Share this post Link to post Share on other sites
MartinT 514 Report post Posted March 18, 2020 Eek! I would get a pin punch of the right size and hammer it out, then replace with a new one. Share this post Link to post Share on other sites